Nissan Altima 2007-2012 Service Manual: Power window control system LH only anti-pinch-sedan
- Basic inspection
- Function diagnosis
- Component diagnosis
- ECU diagnosis
- Precaution
- Symptom diagnosis
- None of the power windows can be operated using any switch
- Driver side power window alone does not operate
- Front passenger side power window alone does not operate
- Rear lh side power window alone does not operate
- Rear rh side power window alone does not operate
- Anti-pinch system does not operate normally (driver side)
- Auto operation does not operate but manual operates normally (driver side)
- Power window retained power operation does not operate properly
- Power window lock switch does not function
- On-vehicle maintenance
- On-vehicle repair
On-vehicle repair
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to
INT-12, "Removal and Installation".
2. Power window main swit ...
Basic inspection
...
Other materials:
B2192, P1611 ID discord, immu-ECM
Description
BCM performs the ID verification with ECM that allows the engine to start.
Start the engine if the ID is OK.
ECM prevents the engine from starting if the ID is not registered. BCM starts
the communication with ECM if
ignition switch is turned ON.
DTC Logic
DTC DETECTION LOGIC ...
Seat belt, buckles, retractors, anchors
and adjusters
Inspection
CAUTION:
• After any collision, inspect all seat belt assemblies, including retractors
and other attached hardwares
(I.e. anchor bolt, guide rail set). Nissan recommends to replace all seat belt
assemblies in use
during a collision, unless not damaged and properly operating afte ...
B2109 steering lock relay
Description
The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN
communication.
IPDM E/R turns the steering lock relay ON and transmits the release of the
steering to BCM.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2109 is displayed with DTC U1000, first perf ...