Nissan Altima 2007-2012 Service Manual: Lan system can system (type 9)
COMPONENT DIAGNOSIS
- Main line between dlc and abs circuit
- ECM branch line circuit
- A-BAG branch line circuit
- BCM branch line circuit
- DLC branch line circuit
- M&A branch line circuit
- STRG branch line circuit
- ABS branch line circuit
- IPDM-E branch line circuit
- Can communication circuit
Can communication circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CONNECTOR INSPECTION
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect all the unit connect ...
Main line between dlc and abs circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and co ...
Other materials:
Compression pressure
On-Vehicle Service
CHECKING COMPRESSION PRESSURE
1. Run the engine until it reaches normal operating temperature.
2. Turn the ignition switch to OFF.
3. Release fuel pressure and leave the fuel pump electrically disconnected.
Refer to EC-1579, "Inspection".
4. Remove all six ...
Additional service when removing battery
negative terminal
Description
Initial setting is necessary when battery terminal is removed.
CAUTION:
The following specified operations are not performed under the non-initialized
condition.
• Auto-up operation
• Anti-pinch function
• Retained power operation
Special Repair
Requirement
INITIALIZ ...
Disassembly and assembly
FRONT DRIVE SHAFT
Disassembly and Assembly (Left Side)
1. Circlip
2. Dust shield
3. Slide joint housing
4. Snap ring
5. Spider assembly
6. Stopper ring
7. Boot band
8. Boot
9. Shaft
10. Damper band
11. Damper
12. Boot band
13. Boot
14. Ball cage / Steel ball / Inner race assembly
...