Nissan Altima 2007-2012 Service Manual: Lan system can system (type 11)
COMPONENT DIAGNOSIS
- Main line between DLC and ABS circuit
- ECM branch line circuit
- A-BAG branch line circuit
- BCM branch line circuit
- DLC branch line circuit
- M&A branch line circuit
- STRG branch line circuit
- ABS branch line circuit
- TCM branch line circuit
- IPDM-E branch line circuit
- Can communication circuit
Can communication circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CONNECTOR INSPECTION
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect all the unit connect ...
Main line between DLC and ABS circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and co ...
Other materials:
Headlamp
Aiming Adjustment
PREPARATION BEFORE ADJUSTING
NOTE:
• For details, refer to the regulations in your area.
• Perform aiming adjustment if the vehicle front body has been repaired and/or
the front combination lamp
assembly has been replaced.
Before performing aiming adjustment, check t ...
Front fog lamp
Bulb Replacement
REMOVAL
The fog lamp is a semi-sealed beam type which uses a replaceable halogen
bulb.
CAUTION:
• Do not touch the glass of bulb directly by hand. Keep grease and other oily
substances away from it.
Do not touch bulb by hand while it is lit or right after being turned ...
Front lower link
Removal and Installation
Removal
1. Remove the front lower link nut and bolt from the knuckle side
and the adjusting bolt and nut from the suspension member side
using power tools.
• Do not reuse the adjusting nut, use a new adjusting nut for
installation.
2. Remove the front lower link ...