Nissan Altima 2007-2012 Service Manual: A-BAG branch line circuit
Diagnosis Procedure
1.CHECK AIR BAG DIAGNOSIS SENSOR UNIT
Check the air bag diagnosis sensor unit. Refer to SRC-3, "Work Flow".
Is the inspection result normal? YES >> Replace the main harness.
NO >> Replace parts whose air bag system has a malfunction.
ECM branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and co ...
AV Branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors ...
Other materials:
Basic inspection
COMPONENT INSPECTION
Inspection
AFTER A COLLISION
WARNING:
Inspect all seat belt assemblies including retractors and attaching hardware
after any collision.
NISSAN/INFINITI recommends that all seat belt assemblies in use during a
collision be replaced
unless the collision was minor and t ...
Idle speed
Description
This describes how to check the idle speed. For the actual procedure, follow
the instructions in “BASIC
INSPECTION”.
Special Repair Requirement
1.CHECK IDLE SPEED
Check idle speed in “DATA MONITOR” mode with CONSULT-III.
Check idle speed with Service $01 of GST.
> ...
P0730 belt damage
Description
TCM selects the gear ratio using the engine load (throttle position), the
primary pulley revolution speed, and
the secondary pulley revolution speed as input signal. Then it changes the
operating pressure of the primary
pulley and the secondary pulley and changes the groove width ...