Nissan Altima 2007-2012 Service Manual: Abbreviations

Abbreviation List

The following ABBREVIATIONS are used:

    How to read wiring diagrams
    Connector symbols Most of connector symbols in wiring diagrams are shown from the terminal side. • Connector symbols shown from the terminal side are enclosed by a single line and followed ...

    Tightening torque of standard bolts
    Tightening Torque Table *: Nominal diameter 1. Special parts are excluded. 2. This standard is applicable to bolts having the following marks embossed on the bolt head. ...

    Other materials:

    B210D starter relay
    Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210D is display ...

    How to follow trouble diagnoses
    Description NOTICE: Trouble diagnoses indicate work procedures required to diagnose problems effectively. Observe the following instructions before diagnosing. • Before performing trouble diagnoses, read the “Work Flow” in each section. • After repairs, re-check that the problem ...

    P0776 pressure control solenoid B performance (sec pressure solenoid valve)
    Description The pressure control solenoid valve B (secondary pressure solenoid valve) regulates the secondary pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe ...