Nissan Altima 2007-2012 Service Manual: Audio unit

Diagnosis Procedure

1.CHECK FUSES

Check that the following fuses are not blown.

Are the fuses OK? YES >> GO TO 2

NO >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.

2.POWER SUPPLY CIRCUIT CHECK

1. Disconnect audio unit connector M43.

2. Check voltage between the audio unit connector M43 and ground.

Are the voltage results as specified? YES >> GO TO 3

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

3.GROUND CIRCUIT CHECK

Inspect audio unit case ground.

Does case ground pass inspection? YES >> Inspection End.

NO >> Repair audio unit case ground.

    Bose speaker AMP
    Diagnosis Procedure 1.CHECK FUSE Check for blown fuses. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of malfunction before installing new fuse. 2.CHECK POWER ...

    Other materials:

    Trouble diagnosis - specification value
    Description The specification (SP) value indicates the tolerance of the value that is displayed in “SPEC” of “DATA MONITOR” mode of CONSULT-III during normal operation of the Engine Control System. When the value in “SPEC” of “DATA MONITOR” mode is within the SP value, the En ...

    P1550 battery current sensor
    Description The power generation voltage variable control enables fuel consumption to be decreased by reducing the engine load which is caused by the power generation of the generator. The battery current sensor is installed to the battery cable at the negative terminal. The sensor measures ...

    Refrigerant pressure sensor
    Removal and Installation for Refrigerant Pressure Sensor REMOVAL 1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service Procedure". 2. Remove the front grille. Refer to EXT-17, "Removal and Installation". 3. Disconnect the refrigerant pressure sensor ...