Nissan Altima 2007-2012 Service Manual: AV control unit
Diagnosis Procedure
1.CHECK FUSE
Check that the following fuses of the AV control unit are not blown.
Are the fuses OK? YES >> GO TO 2
NO >> Be sure to eliminate cause of malfunction before installing new fuse.
2.CHECK POWER SUPPLY CIRCUIT
Check voltage between AV control unit harness connector and ground.
Are the voltage tests as specified? YES >> GO TO 3
NO >> Check harness between AV control unit and fuse.
3.CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect AV control unit connectors.
3. Check continuity between AV control unit harness connector M47 terminal 19 and ground.
Does continuity exist? YES >> Inspection End.
NO >> Repair harness or connector.
Rear view camera control unit
Diagnosis Procedure
1.CHECK FUSE
Check that the following fuses of the rear view camera control unit are not
blown.
Are the fuses OK?
YES >> GO TO 2
NO >> Be sure to eliminate cau ...
Other materials:
P1715 input speed sensor (primary
speed sensor)
Description
ECM receives primary speed sensor signal from TCM through CAN communication
line. ECM uses this signal
for engine control.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC P1715 is displayed with DTC UXXXX, first perform the trouble diagnosis
for DTC U1000,XXXX.
• If DTC P ...
Door outside molding
Removal and Installation
1. Front door outside molding
2. Front door
Door Outside Molding
Removal
1. Open the front door window fully.
2. Remove the side view mirror. Refer to MIR-19, "Removal and Installation".
3. Lift and twist front door molding from rear end, disconnect ...
B2014 chain of strg-immu
Description
BCM performs the ID verification with the steering lock unit to release the
steering. BCM starts the communication
with the steering lock unit when Intelligent Key is carried into the passenger
compartment and the pushbutton
ignition switch is pressed.
DTC Logic
DTC DETECTION L ...