Nissan Altima (L32) 2007-2012 Service Manual ≻ Security control system sedan with intelligent key ≻ Component diagnosis ≻ B2108 steering lock relay

Nissan Altima (L32) 2007-2012 Service Manual: B2108 steering lock relay

Description

The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN communication.

IPDM E/R turns the steering lock relay ON and transmits the release of the steering to BCM.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B2108 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-235, "DTC Logic".

• If DTC B2108 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-236, "DTC Logic".

DTC CONFIRMATION PROCEDURE

DTC CONFIRMATION PROCEDURE

1. Press the push-button ignition switch under the following conditions and wait for at least 1 second.

- CVT selector lever is in the P position

- Do not depress the brake pedal.

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-241, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK FUSE

1. Turn ignition switch OFF.

2. Check 10A fuse (No. 40, located in IPDM E/R).

Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".

NO >> Check the following.

• Harness for open or short between IPDM E/R and battery

• Fuse

B2014 chain of strg-immu

Description BCM performs the ID verification with the steering lock unit to release the steering. BCM starts the communication with the steering lock unit when Intelligent Key is carried into the ...

B2109 steering lock relay

Description The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN communication. IPDM E/R turns the steering lock relay ON and transmits the release of the steering to B ...

Other materials:

Shift lock release
If the battery charge is low or discharged, the shift lever may not be moved from the P (Park) position even with the brake pedal depressed and the shift lever button pressed. It will be necessary to jump start or have your battery charged. For additional information, see "Jump starting". Contact a ...

LED Daytime Running Lights (DRL) system
The LED DRL automatically illuminate at 100% intensity when the engine is started and the parking brake released. The LED Daytime Running Lights (DRL) operate with the headlight switch in any position. When you turn the headlight switch to the position for full illumination, the LED DRL illuminate ...

Steering Assist
WARNING Failure to follow the warnings and instructions for proper use of the Steering Assist could result in serious injury or death. The Steering Assist is not a replacement for proper driving procedures and is not designed to correct careless, inattentive or absent-minded driving. The Steer ...