Nissan Altima (L32) 2007-2012 Service Manual: B260B steering lock unit
Description
The electronic steering column lock performs the check by itself according to
the steering status.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Press the push-button ignition switch, when steering is locked.
2. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected?
YES >> Refer to SEC-296, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Check “Self diagnostic result” with CONSULT-III.
3. Touch “ERASE”.
4. Perform DTC Confirmation Procedure.
See SEC-296, "DTC Logic".
Is the DTC B260B displayed again?
YES >> Replace electronic steering column lock.
NO >> Inspection End.
Description
There are 2 switches in the electronic steering column lock (steering
lock/unlock switch 1 and 2). BCM compares
those two switches conditions to judge the present steering status.
DT ...
Description
The electronic steering column lock performs the check by itself according to
the steering status.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMA ...
Other materials: I-LI system limitations
WARNING
Listed below are the system limitations
for the I-LI system. Failure to follow the
warnings and instructions for proper
use of the I-LI system could result in
serious injury or death.
The I-LI system may activate if you
change lanes without first activating
your turn signal or, for examp ...
Changing a flat tire
If you have a flat tire, follow the instructions
below:
Stopping the vehicle
1. Safely move the vehicle off the road and
away from traffic.
2. Turn on the hazard warning flashers.
3. Park on a level surface and apply the
parking brake. Move the shift lever to P
(Park).
4. Turn off the engine.
5. ...
Windshield-washer fluid
Windshield-washer fluid reservoir
Fill the windshield-washer fluid reservoir
periodically. Add windshield-washer fluid
when the "Low Washer Fluid" warning appears
in the vehicle information display.
To check the fluid level with the dip tube,
use your finger to plug the center hole A of
the cap/tu ...