Nissan Altima (L32) 2007-2012 Service Manual ≻ Security control system sedan without intelligent key ≻ Component diagnosis ≻ B260F engine status

Nissan Altima (L32) 2007-2012 Service Manual: B260F engine status

Description

BCM receives the engine status signal from ECM via CAN communication.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B260F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-433, "DTC Logic".

• If DTC B260F is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-434, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions.

- CVT selector lever is in the P position.

- Do not depress the brake pedal.

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-491, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Check “Self diagnostic result” with CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC Confirmation Procedure.

See SEC-491, "DTC Logic".

Is the DTC B260F displayed again? YES >> GO TO 2

NO >> Inspection End.

2.REPLACE ECM

1. Replace ECM.

2. Refer to EC-560, "BASIC INSPECTION : Special Repair Requirement" (QR25DE except California) or EC-24, "BASIC INSPECTION : Special Repair Requirement" (QR25DE California).

>> Inspection End.

B260D steering lock unit

Description The electronic steering column lock performs the check by itself according to the steering lock status (before lock, after lock and unlock). DTC Logic DTC DETECTION LOGIC DTC CON ...

B2612 steering status

Description There are 2 switches in the electronic steering column lock. IPDM E/R compares those 2 switches conditions to judge the present steering status and transmit the result to BCM via CAN ...

Other materials:

Rear-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudden stop o ...

Wiper and washer switch
Switch operation WARNING In freezing temperatures the washer solution may freeze on the windshield and obscure your vision which may lead to an accident. Warm the windshield with the defroster before you wash the windshield. CAUTION Do not operate the washer continuously for more than 30 seconds ...

How to park with predicted course lines
WARNING If the tires are replaced with different sized tires, the predicted course lines may be displayed incorrectly. On a snow-covered or slippery road, there may be a difference between the predicted course line and the actual course line. If the battery is disconnected or becomes disch ...