Nissan Altima 2007-2012 Service Manual: Basic inspection

Diagnosis and repair workflow
Work Flow INTRODUCTION The TCM receives a signal from the vehicle speed sensor, PNP switch and provides shift control or lock-up control via CVT solenoid valves. The TCM also communicates wit ...

Other materials:

BCM branch line circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the BCM for damage, bend and loose connection (unit side and connector side). Is the inspec ...

B210E starter relay
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210E is displaye ...

Self-diagnosis function
Diagnosis Description SELF-DIAGNOSIS SYSTEM The self-diagnosis system is built into the front air control to quickly locate the cause of malfunctions. SELF-DIAGNOSIS FUNCTION The self-diagnosis system diagnoses sensors, door motors, blower motor, etc. by system line. Refer to applicable se ...