Nissan Altima 2007-2012 Service Manual: BCM (Body control module)

Reference Value

VALUES ON THE DIAGNOSIS TOOL

Terminal Layout

Physical Values

1: Sedan only

2: With LH front window anti-pinch

3: With LH and RH front window anti-pinch

4: With Intelligent Key

5: Without Intelligent Key

Wiring Diagram - ENGINE START FUNCTION - WITH INTELLIGENT KEY

Wiring Diagram - VEHICLE SECURITY SYSTEM - WITH INTELLIGENT KEY

Wiring Diagram - NVIS - WITH INTELLIGENT KEY

Fail Safe

DTC Inspection Priority Chart

If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart.

DTC Index

NOTE:

Details of time display

• CRNT: Displays when there is a malfunction now or after returning to the normal condition until turning ignition switch OFF → ON again.

• 1 - 39: Displayed if any previous malfunction is present when current condition is normal. It increases like 1 → 2 → 3...38 → 39 after returning to the normal condition whenever ignition switch OFF → ON. The counter remains at 39 even if the number of cycles exceeds it. It is counted from 1 again when turning ignition switch OFF → ON after returning to the normal condition if the malfunction is detected again.

    Ecu diagnosis
    ...

    IPDM E/R (Intelligent power distribution module engine room)
    Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES Wiring Diagram — Sedan Fail Safe CAN COMMUNICATION CONTROL When CAN communication w ...

    Other materials:

    P0453 Evap control system pressure sensor
    Description The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously condu ...

    P0182, P0183 FTT Sensor
    Description The fuel tank temperature sensor is used to detect the fuel temperature inside the fuel tank. The sensor modifies a voltage signal from the ECM. The modified signal returns to the ECM as the fuel temperature input. The sensor uses a thermistor which is sensitive to the change in te ...

    Compass
    Description DESCRIPTION With the ignition switch in the ON position, and the mode (N) switch ON, the compass display will indicate the direction the vehicle is heading. Vehicle direction is displayed as follows: • N: north • E: east • S: south • W: west ZONE VARIATION SETTING P ...