Nissan Altima (L32) 2007-2012 Service Manual: Bluetooth control unit
Diagnosis Procedure
1.CHECK FUSE
Check that the following fuses of the Bluetooth control unit are not blown.
Are the fuses OK?
YES >> GO TO 2
NO >> Be sure to eliminate cause of malfunction before installing new fuse.
2.CHECK POWER SUPPLY CIRCUIT
Check voltage between Bluetooth control unit harness connector
and ground.
Are the voltage results as specified?
YES >> GO TO 3
NO >> Check harness between Bluetooth control unit and fuse.
3.CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect Bluetooth control unit connector B55.
3. Check continuity between Bluetooth control unit harness connector
and ground.
Does continuity exist?
YES >> Inspection End.
NO >> Repair harness or connector.
Diagnosis Procedure
1.CHECK FUSES
Check that the following fuses are not blown.
Are the fuses OK?
YES >> GO TO 2
NO >> If fuse is blown, be sure to eliminate cause of malfunction be ...
Diagnosis Procedure
1.CHECK POWER SUPPLY CIRCUIT (MICROPHONE SIDE)
Check voltage between microphone harness connector and ground.
Is proper voltage present?
YES >> GO TO 4
NO >> G ...
Other materials: RearView Monitor system limitations
WARNING
Listed below are the system limitations
for RearView Monitor. Failure to operate
the vehicle in accordance with
these system limitations could result in
serious injury or death.
The system cannot completely eliminate
blind spots and may not show
every object.
Underneath the bumper and t ...
Intelligent Cruise Control (ICC)
(for vehicles with ProPILOT Assist)
WARNING
Failure to follow the warnings and instructions
for proper use of the ICC system
could result in serious injury or
death.
The ICC system is only an aid to assist
the driver and is not a collision
warning or avoidance device. It is recommended for
highway use only and
it is not intended ...
Regulatory information
FCC Regulatory information
CAUTION: To maintain compliance with
FCC’s RF exposure guidelines, use only
the supplied antenna. Unauthorized antenna,
modification, or attachments
could damage the transmitter and may
violate FCC regulations.
Operation is subject to the following two
condition ...