Nissan Altima 2007-2012 Service Manual: Body component parts

Underbody Component Parts

1. Upper dash assembly

2. Lower dash crossmember reinforcement

3. Rear crossmember (RH, LH)

4. Front crossmember (RHLH)

5. Front sidemember reinforcement upper (RHLH)

6. Front floor assembly (RHLH)

7. Front sidemember reinforcement lower

8. Front floor center

9. Front suspension member plate (RH, LH)

10. Front sidemember cap (RH, LH)

11. Front sidemember (RH, LH)

12. Outrigger (RH, LH)

13. Lower hoodledge support (RH, LH)

14. Radiator core support (RH, LH)

15. Front sidemember assembly (RH, LH)

16. Strut housing bracket (RH, LH)

17. Strut housing (RH, LH)

18. Radiator core support side (RH, LH)

19. Front sidemember extension (RH, LH)

20. Closing plate (RH, LH)

21. Hoodledge assembly (RH, LH)

22. Upper hoodledge (RH, LH)

23. Upper hoodledge lower (RH, LH)

24. Dash side (RH, LH)

25. Inner sill (RH, LH)

26. Outer sill support bracket (RH, LH)

27. Outer sill (RH, LH)

28. Rear floor front

29. Rear seat crossmember

30. Rear seat crossmember lower

31. Rear floor rear

32. Rear floor rear side (RH, LH)

33. Rear side member (RH, LH)

34. Rear side member extension (RH, LH)

35. Rear side member assembly (RH, LH)

36. Rear wheel housing outer (RH, LH)

Body Component Parts

1. Roof panel assembly

2. Rear roof rail

3. 3rd roof rail

4. 2nd roof rail

5. 1st roof rail

6. Front roof rail

7. Sun roof panel assembly

8. Hood assembly

9. Roof side rail reinforcement (RH, LH)

10. Outer roof side rail (RH, LH)

11. Inner center pillar (RH,LH)

12. Front pillar reinforcement (RHLH)

13. Fender (RH, LH)

14. Front pillar inner (RH, LH)

15. Center pillar reinforcement (RH, LH)

16. Side body (RH, LH)

17. Rear fender (RH, LH)

18. Rear fender corner (RH, LH)

19. Front door assembly (RH, LH)

20. Outer front door panel (RH, LH)

21. Rear door assembly (RH, LH)

22. Outer rear door panel (RH, LH)

23. Rear roof rail reinforcement (RH, LH)

24. Rear wheel well housing outer (RH, LH)

25. Rear pillar inner reinforcement (RH, LH)

26. Trunk lid assembly (RH, LH)

27. Rear panel assembly

28. Rear bumper fascia center bracket (RH, LH)

    Corrosion protection
    Description To provide improved corrosion prevention, the following anti-corrosive measures have been implemented in NISSAN production plants. When repairing or replacing body panels, it is nec ...

    Other materials:

    Air conditioning cut control
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This signal is sent to the ECM via the CAN communication line. *2: ECM determines the start signal status by the signals of engine speed and battery voltage. SYSTEM DESCRIPTION This system improves engine operation when t ...

    Front wiper blade refill
     Removal and Installation REMOVAL 1. Remove the front wiper blade. Refer to WW-115, "FRONT WIPER BLADE : Removal and Installation". 2. Hold the wiper blade refill lip at the end (A) of the front wiper blade (1) with a suitable tool (B) as shown, and pull it firmly in the direc ...

    B1049 – B1052, B1054 – B1057 driver airbag module
    Description DTC B1049 – B1052, B1054 – B1057 DRIVER AIRBAG MODULE The driver air bag module is dual stage and wired to the air bag diagnosis sensor unit through the spiral cable. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the driver air bag ...