Nissan Altima 2007-2012 Service Manual: Body sealing

Description

The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of sealant and not to allow other unaffected parts to come into contact with the sealant.

    Corrosion protection
    Description To provide improved corrosion prevention, the following anti-corrosive measures have been implemented in NISSAN production plants. When repairing or replacing body panels, it is nece ...

    Body construction
    Body Construction ...

    Other materials:

    P0715 input speed sensor (pri speed sensor)
    Description The input speed sensor (primary speed sensor) detects the primary pulley revolution speed and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has be ...

    P2118 throttle control motor
    Description The throttle control motor is operated by the ECM and it opens and closes the throttle valve. The current opening angle of the throttle valve is detected by the throttle position sensor and it provides feedback to the ECM to control the throttle control motor to make the thrott ...

    On-vehicle maintenance
    FRONT WHEEL HUB Inspection • Move wheel hub and bearing assembly in the axial direction by hand. Make sure there is no looseness of wheel bearing. Axial end play : 0.05 mm (0.002 in) or less • Rotate wheel hub and make sure that is no unusual noise or other irregular conditions. If ther ...