Nissan Altima (L32) 2007-2012 Service Manual: Both side headlamps (LO) are not
turned on
Description
The headlamps (both sides) do not turn ON in any lighting switch setting.
Diagnosis Procedure
1.CHECK COMBINATION SWITCH
Check the combination switch. Refer to BCS-10, "System Description".
Is the combination switch normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning part.
2.CHECK HEADLAMP (LO) REQUEST SIGNAL INPUT
1. Select "HL LO REQ" of IPDM E/R DATA MONITOR item.
2. With operating the lighting switch, check the monitor status.
Is the item status normal?
YES >> GO TO 3
NO >> Replace BCM. Refer to BCS-96, "Removal and Installation" .
3.HEADLAMP (LO) CIRCUIT INSPECTION
Check the headlamp (LO) circuit. For Halogen headlamps, refer to EXL-42,
"HEADLAMP (HALOGEN) : Diagnosis
Procedure". For Xenon headlamps, refer to EXL-44, "HEADLAMP (XENON) : Diagnosis
Procedure".
Is the headlamp (LO) circuit normal?
YES >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation" .
NO >> Repair or replace the malfunctioning part.
Description
The headlamps (both sides) do not switch to high beam when the lighting
switch is in the HI or PASS setting.
Diagnosis Procedure
1.COMBINATION SWITCH INSPECTION
Check the combinati ...
Description
The parking, license plate and tail lamps do not turn ON in with any lighting
switch setting.
Diagnosis Procedure
1.COMBINATION SWITCH INSPECTION
Check the combination switch. Refe ...
Other materials: Intelligent Driver Alertness (I-DA)
system limitations
WARNING
Listed below are the system limitations
for the I-DA system. Failure to operate
the vehicle in accordance with these
system limitations could result in serious
injury or death.
The I-DA system may not operate
properly and may not provide an
alert in the following conditions:
Poor road ...
System temporarily unavailable
For vehicles with the 7 inch (18 cm) display
For vehicles with the 5 inch (13 cm) display
When radar blockage is detected, the system
will be deactivated automatically.
The "Unavailable: Side Radar Obstruction"
warning message will appear in the vehicle
information display.
The system is not ava ...
Radio
Place the ignition switch in the ACC or ON
position and press the PUSHbutton
to turn the radio on. If you listen to the radio
with the engine not running, the ignition
switch should be placed in the ACC
position.
Radio reception is affected by station signal
strength, distance from radio transmitte ...
Both side headlamps do not switch
to high beam
Parking, license plate and tail
lamps are not turned on