Nissan Altima 2007-2012 Service Manual: Camera on signal circuit (sedan)

Description

When the selector lever is placed in the R position, the rear view camera control unit sends a camera ON signal to the rear view camera.

Diagnosis Procedure

1.CHECK CAMERA ON SIGNAL CIRCUIT CONTINUITY

1. Turn ignition switch OFF.

2. Disconnect rear view camera control unit connector and rear view camera connector.

3. Check continuity between rear view camera control unit harness connector B31 (A) terminal 8 and rear view camera harness connector B35 (B) terminal 1.


4. Check continuity between rear view camera control unit harness


4. Check continuity between rear view camera control unit harness connector B31 (B) terminal 8 and ground.

Is inspection result OK?


Is inspection result OK? YES >> GO TO 2

NO >> Repair harness or connector.

2.CHECK CAMERA ON SIGNAL VOLTAGE

1. Connect rear view camera control unit connector and rear view camera connector.

2. Turn ignition switch ON.

3. Check voltage between rear view camera control unit harness connector B31 terminal 8 and ground.


Is inspection result OK?


Is inspection result OK? YES >> Replace rear view camera. Refer to AV-457, "Removal and Installation".

NO >> Replace rear view camera control unit. Refer to AV-458, "Removal and Installation - Sedan".

    Camera on signal circuit (coupe)
    Description When the selector lever is placed in the R position, the rear view camera control unit sends a camera ON signal to the rear view camera. Diagnosis Procedure 1.CHECK CAMERA ON SIGNAL ...

    Camera image signal circuit (camera control unit to av control unit)
    Description Rear view camera image signals are transmitted from the rear view camera control unit to the AV control unit using the image signal circuits. Diagnosis Procedure 1.CHECK CAMERA IMAG ...

    Other materials:

    Service data and specifications (SDS)
    Standard and Limit GENERAL SPECIFICATIONS DRIVE BELTS CYLINDER HEAD * Approximately 80В°C (176В°F) Available Valve Lifter Valve Spring CAMSHAFT AND CAMSHAFT BEARING CYLINDER BLOCK PISTON, PISTON RING, AND PISTON PIN Available Piston Piston Ring CON ...

    Cylinder head
    Removal and Installation 1. Cylinder head 2. Cylinder head gasket 3. Cylinder head bolt A. Follow installation procedure REMOVAL 1. Remove the engine and transaxle assembly. Refer to EM-72, "Removal and Installation". 2. Remove the timing chain. Refer to EM-52, "Removal ...

    Front drive shaft
    Removal and Installation (Left Side) 1. Drive shaft 2. Cotter pin REMOVAL 1. Remove wheel and tire. Refer to WT-66, "Adjustment". 2. Remove wheel sensor from steering knuckle. Refer to BRC-63, "Removal and Installation" (ABS), BRC- 134, "Removal and Installation& ...