Nissan Altima 2007-2012 Service Manual: Component diagnosis

Diagnosis system (BCM)
CONSULT-III Function (BCM) CONSULT-III DIAGNOSTIC MODES CONSULT-III can display each diagnostic item using the diagnostic test modes shown following. DESCRIPTION During driving, the tire pres ...

C1708 - c1711 data from transmitter not being received
Description Tire pressure data for one or more transmitters is not being received by the BCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.ID REGISTRATION AND VEHICLE DRIVING ...

Other materials:

B210D starter relay
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210D is displaye ...

U1001 Can comm circuit
Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each c ...

Cooling fan
Removal and Installation 1. Fan blade 2. Fan shroud and motor assembly REMOVAL 1. Drain engine coolant from the radiator. Refer to CO-12, "Changing Engine Coolant". CAUTION: Perform when engine is cold. 2. Remove air cleaner duct assembly. Refer to EM-25, "Removal and In ...