Nissan Altima 2007-2012 Service Manual: Component diagnosis
- B1049 – B1052, B1054 – B1057 driver airbag module
- B1065 – B1068, B1070 – B1073 passenger airbag module
- B1134 – B1137 side airbag module LH
- B1129 – B1132 side airbag module RH
- B1150 – B1153 side curtain air bag module LH
- B1145 – B1148 side curtain air bag module RH
- B1086 – B1089 seat belt pre-tensioner LH
- B1081 – B1084 seat belt pre-tensioner RH
- B1033 – B1035 crash zone sensor
- B1118 – B1120 satellite sensor LH
- B1113 – B1115 satellite sensor RH
- B1xxx air bag diagnosis sensor unit
- B1023 passenger air bag off indicator
- B1017 – b1022 occupant classification system
- B1209 – b1210 collision detection
On board diagnostic (OBD) system
Trouble Diagnosis Introduction
CAUTION:
• Do not use electrical test equipment on any circuit related to the SRS unless
instructed to do so in
this Service Manual. SRS wiring harnesses can be i ...
B1049 – B1052, B1054 – B1057 driver airbag
module
Description
DTC B1049 – B1052, B1054 – B1057 DRIVER AIRBAG MODULE
The driver air bag module is dual stage and wired to the air bag diagnosis
sensor unit through the spiral cable.
The air ba ...
Other materials:
Vehicle Information Display
The vehicle information display is located to the
left of the speedometer. It displays such items as:
● Vehicle settings
● Trip computer information
● Drive system warnings and settings (if so
equipped)
● Cruise control system information
● NISSAN Intelligent K ...
Power supply and ground circuit
Diagnosis Procedure
1.INSPECTION START
Start engine.
Is engine running?
YES >> GO TO 8.
NO >> GO TO 2.
2.CHECK ECM POWER SUPPLY CIRCUIT-I
1. Turn ignition switch OFF and then ON.
2. Check the voltage between ECM harness connector and
ground.
Is the inspection result n ...
Remote starting the vehicle
perform the following:
1. Aim the Intelligent Key at the vehicle.
2. Press the LOCK button to lock
all
doors.
3. Within 5 seconds press and hold the
remote start button until the turn signal lights
illuminate. If the vehicle is not within view
press and hold the remote start
butto ...