Other materials:

P0643 Sensor power supply
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. ...

Thermostat and thermostat housing
Removal and Installation 1. Thermostat 2. O-ring 3. Engine coolant inlet 4. Water control valve 5. Gasket 6. Engine coolant outlet 7. Copper washer 8. Engine coolant temperature sensor 9. Heater pipe A. To electric throttle control B. To oil cooler C. To heater D. To heater E. To ele ...

P0500 VSS
Description The vehicle speed signal is sent to the combination meter from the “ABS actuator and electric unit (control unit)” by CAN communication line. The combination meter then sends a signal to the ECM by CAN communication line. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P050 ...