Nissan Altima 2007-2012 Service Manual: Diagnosis system (audio unit)

Diagnosis Description

Self-diagnosis mode can check the following items.

• Audio unit hardware/software versions

• Continuity of each speaker channel

• Continuity of each audio unit switch

OPERATION PROCEDURE

1. Turn ignition switch to the ACC position.

2. Turn the audio unit off.

3. While pressing the “AUDIO” button, turn the volume control dial clockwise or counterclockwise 30 clicks or more. When the selfdiagnosis mode is started, a short beep will be heard.

4. Initially, all display segments will be illuminated.

Version Check

1. Press the “AUDIO” switch to enter version diagnostics. “Software” (audio software version) is displayed.

2. Press the “AUDIO” switch again to display the “Hardware” (audio hardware version).

3. Press the “AUDIO” switch again to display the “CD Mech” (CD mechanism version).

4. Press the “AUDIO” switch again to display the “SDARS” (satellite radio version).

Channel Check Diagnostics

When all segments are illuminated, press the “TUNE” up switch to enter channel check diagnostics. The self-diagnostic function will then send a tone to each channel (FL, RL, RR, FR) for 1 second.

Button Check Diagnostics

When all segments are illuminated, press the “TUNE” down switch to enter button check diagnostics. When each audio unit switch is pressed, a tone will sound and the switch name will be displayed.

    Audio system (sedan)
    System Diagram System Description AUDIO SYSTEM The audio system consists of the following components • Audio unit • Window antenna • Steering wheel audio control switches • Front door ...

    Other materials:

    Auto operation does not operate but manual operates normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-108, "POWER WINDOW MAIN SWITCH : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the malfunctioning parts. 2. ...

    BCM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the BCM for damage, bend and loose connection (unit side and connector side). Is the inspec ...

    Rocker cover
    Exploded View 1. Rocker cover (RH) 2. Rocker cover gasket (RH) 3. Rocker cover gasket (LH) 4. Rocker cover (LH) A. Follow installation procedure Removal and Installation LH REMOVAL 1. Remove the engine cover, using power tool. 2. Remove front air duct. 3. Remove blow by hose from ...