Nissan Altima 2007-2012 Service Manual: Disassembly and assembly
CENTER CONSOLE ASSEMBLY
Exploded View
1. M/T finisher
2. CVT finisher
3. Storage bin (if equipped)
4. CD changer console bracket (if equipped)
5. CD changer bracket LH (if equipped)
6. CD changer bracket RH (if equipped)
7. CD changer finisher (if equipped)
8. Console
9. Console screw cover (LH)
10. Console floor bracket
11. Console rear finisher (with rear duct)
12. Console rear finisher (without rear duct)
13. Console lid assembly bracket
14. Console lid assembly
15. Cup holder CVT
16. Cup holder M/T
Disassembly and Assembly
DISASSEMBLY
1. Remove the console assembly. Refer to IP-12, "Removal and Installation".
2. Remove the cup holder screws and then remove the cup holder assembly.
3. Remove the console lid screws and remove the console lid.
4. Remove the console rear finisher.
5. Remove the console lid assembly bracket.
6. Remove the power socket from the console. Refer to PWO-5, "Removal and Installation".
ASSEMBLY
Assembly is in the reverse order of disassembly.
On-vehicle repair
INSTRUMENT PANEL ASSEMBLY
Exploded View
1. Center speaker grille
2. Tweeter speaker grille (LH)
3. Instrument panel
4. Instrument side mask (LH)
5. Combination meter
6. Lower knee protector ...
Seat Coupe
...
Other materials:
P0181 FTT Sensor
Description
The fuel tank temperature sensor is used to detect the fuel temperature
inside the fuel tank. The sensor modifies a voltage signal from
the ECM. The modified signal returns to the ECM as the fuel temperature
input. The sensor uses a thermistor which is sensitive to the
change in te ...
Audio system (coupe)
System Diagram
System Description
AUDIO SYSTEM
The audio system consists of the following components
• Audio unit
• BOSE speaker amp.
• Window antenna
• Steering wheel audio control switches
• Door speakers
• Front tweeters
• Center speaker
• Rear tweeters
• Rear sub ...
ECU Diagnosis
ECM
Reference Value
VALUES ON THE DIAGNOSIS TOOL
Remarks:
● Specification data are reference
values.
● Specification data are output/input
values which are detected or supplied by the ECM at the connector.
* Specification data may not be directly related to the ...