Nissan Altima 2007-2012 Service Manual: Disassembly and assembly

COMBINATION METER

Disassembly and Assembly

DISASSEMBLY

1. Remove the combination meter. Refer to IP-12, "Removal and Installation".

2. Remove the combination meter lens (1) from the combination meter (2).

ASSEMBLY

Assembly is in the reverse order of disassembly.

    On-vehicle repair
    COMBINATION METER Removal and Installation REMOVAL 1. Open the fuse block cover, remove the instrument lower cover screw (A), then remove the instrument lower cover (1). • Disconnect the har ...

    Other materials:

    Engine start function symptoms
    Symptom Table Engine cannot be started with all keyfobs. CAUTION: • Follow Trouble Diagnosis Flowchart referring to “SEC-411, "Work Flow"”. Determine malfunctioning condition before performing this diagnosis. • Check that vehicle is under the condition shown in “Condit ...

    P2138 APP sensor
    Description The accelerator pedal position sensor is installed on the upper end of the accelerator pedal assembly. The sensor detects the accelerator position and sends a signal to the ECM. Accelerator pedal position sensor has two sensors. These sensors are a kind of potentiometers which tra ...

    Door switch
    Description Detects door open/close condition and transmits the signal to BCM. Component Function Check 1. CHECK FRONT DOOR SWITCH INPUT SIGNAL Check (“DOOR SW-DR” and “DOOR SW-AS”) in “DATA MONITOR” mode with CONSULT-III. Refer to BCS- 34, "RETAINED PWR : CONSULT-III Functi ...