Nissan Altima 2007-2012 Service Manual: Disassembly and assembly
- Transaxle assembly
- Input shaft and gear
- Mainshaft AND Gear
- Reverse idler shaft and gear
- Final drive
- Shift fork and fork rod
Removal and installation
TRANSAXLE ASSEMBLY
Exploded View
1. Transaxle assembly
2. LH engine mounting bracket
A. Refer to TM-26, "Removal and Installation"
Removal and Installation
CAUTON:
If transaxle asse ...
Transaxle assembly
Exploded View
CASE AND HOUSING
1. Differential side oil seal
2. Clutch housing
3. Input shaft oil seal
4. Oil channel
5. Oil gutter A
6. Back-up lamp switch
7. Plunger
8. Gasket
9. Plug
1 ...
Other materials:
Evap leak check
Inspection
CAUTION:
• Do not use compressed air or a high pressure pump.
• Do not exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP system.
NOTE:
• Do not start engine.
• Improper installation of EVAP service port adapter [commercial service tool:
(J-41413-OBD)] to th ...
Precautions on seat belt usage
If you are wearing your seat belt properly adjusted
and you are sitting upright and well back in
your seat with both feet on the floor, your chances
of being injured or killed in an accident and/or the
severity of injury may be greatly reduced.
NISSAN strongly encourages you and all of your ...
Diagnosis and repair workflow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1. GET INFORMATION FOR SYMPTOM
Get the detailed information from the customer about the symptom (the
condition and the environment when
the incident/malfunction occurred).
>> GO TO 2
2. CHECK DTC
1. Check DTC.
2. Perform the following p ...