Nissan Altima (L32) 2007-2012 Service Manual ≻ Lan system can system (type 10) ≻ DLC branch line circuit

Nissan Altima (L32) 2007-2012 Service Manual: DLC branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

Check the resistance between the data link connector terminals.

Is the measurement value within the specification? YES (Present error)>>Check CAN system type decision again.

YES (Past error)>>Error was detected in the data link connector branch line circuit.

NO >> Repair the data link connector branch line.

BCM branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

M&A branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

Other materials:

Moving Object Detection (MOD) (if so equipped)
CAMERA button WARNING Failure to follow the warnings and instructions for proper use of the Moving Object Detection (MOD) system could result in serious injury or death The MOD system is not a substitute for proper vehicle operation and is not designed to prevent contact with objects surrou ...

Front manual seat adjustment (if so equipped)
Your vehicle seats can be adjusted manually. For additional information about adjusting the seats, refer to the steps outlined in this section. WARNING Before driving the vehicle, return the seatback to an upright seating position after manually releasing it. Also, make sure the seat is locked in p ...

Continuously Variable Transmission (CVT)
WARNING Do not depress the accelerator pedal while shifting from P (Park) or N (Neutral) to R (Reverse), D (Drive), L (Low) or manual shift mode (if so equipped). Always depress the brake pedal until shifting is completed. Failure to do so could cause you to lose control and have an acciden ...