Nissan Altima 2007-2012 Service Manual: Driver side door mirror defogger

Description

Heats the heating wire with the power supply from the rear window defogger relay to prevent the door mirror from fogging up.

Component Function Check

1. CHECK DOOR MIRROR DEFOGGER LH

Check that heating wire of door mirror defogger LH is heated when turning the rear window defogger switch ON.

Is the inspection result normal? YES >> Door mirror defogger is OK.

NO >> Refer to DEF-15, "Diagnosis Procedure".

Diagnosis Procedure

1. CHECK POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect door mirror LH.

3. Turn ignition switch ON.

4. Check voltage between door mirror LH connector and ground.

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace harness.

2. CHECK GROUND CIRCUIT

1. Turn ignition switch OFF.

2. Check continuity between door mirror LH connector and ground.

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace harness.

3. CHECK DOOR MIRROR DEFOGGER LH

Check door mirror defogger LH.

Refer to DEF-16, "Component Inspection".

Is the inspection result normal? YES >> GO TO 4

NO >> Replace door mirror. Refer to MIR-19, "Removal and Installation".

4. CHECK INTERMITTENT INCIDENT

Check intermittent incident.

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Check the following.

• Battery power supply circuit.

• Fuse block (J/B).

NO >> Repair or replace the malfunctioning parts.

Component Inspection

1. CHECK DOOR MIRROR DEFOGGER LH

1. Turn ignition switch OFF.

2. Disconnect door mirror LH.

3. Check continuity between door mirror terminals.

Is the inspection result normal? YES >> Inspection End.

NO >> Replace door mirror LH. Refer to MIR-19, "Removal and Installation".

    Rear window defogger power supply and ground circuit
    Description Heats the heating wire with the power supply from the rear window defogger relay to prevent the rear window from fogging up. Component Function Check 1. CHECK REAR WINDOW DEFOGGER ...

    Passenger side door mirror defogger
    Description Heats the heating wire with the power supply from the rear window defogger relay to prevent the door mirror from fogging up. Component Function Check 1.CHECK DOOR MIRROR DEFOGGER RH ...

    Other materials:

    P0778 pressure control solenoid B electrical (sec pressure solenoid valve)
    Description The pressure control solenoid valve B (secondary pressure solenoid valve) regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle a ...

    P0550 PSP Sensor
    Description Power steering pressure (PSP) sensor is installed to the power steering high-pressure tube and detects a power steering load. This sensor is a potentiometer which transforms the power steering load into output voltage, and emits the voltage signal to the ECM. The ECM controls t ...

    Parking brake switch signal circuit
    Description Transmits the parking brake switch signal to the combination meter. Component Function Check 1.COMBINATION METER INPUT SIGNAL 1. Select “METER/M&A” on CONSULT-III. 2. Monitor “PKB SW” of “DATA MONITOR” while applying and releasing the parking brake. >> ...