Nissan Altima 2007-2012 Service Manual: DTC B2205 Vehicle speed circuit

Description

The ABS actuator and electric unit (control unit) provides a vehicle speed signal to the combination meter via CAN communication lines.

DTC Logic

Diagnosis Procedure

Symptom: Displays “VEHICLE SPEED CIRC [B2205]” as a self-diagnosis result of combination meter.

1.CHECK COMBINATION METER INPUT SIGNAL

1. Start engine and select “METER/M&A” on CONSULT-III.

2. Using “SPEED METER” on “DATA MONITOR”, compare the value of DATA MONITOR with speedometer pointer of combination meter. Speedometer and DATA MONITOR indications should be close.

Is the inspection result normal? YES >> Perform ABS actuator and electric unit (control unit) self-diagnosis. Refer to BRC-12, "CONSULTIII Function (ABS)" (with ABS), BRC-76, "CONSULT-III Function (ABS)" (with TCS/ABS) or BRC- 149, "CONSULT-III Function (ABS)" (with VDC/TCS/ABS).

NO >> Replace combination meter. Refer to MWI-176, "Removal and Installation".

    DTC U1000 can communication
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure Symptom: Displays “CAN COMM CIRC [U1000]” as a self-diagnosis result of combination meter. 1.CHECK CAN COMMUNICATION Select “SELF-DIA ...

    Other materials:

    Common ITEM
     Diagnosis Description BCM CONSULT-III FUNCTION CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the following for all sub system s ...

    On-vehicle repair
    INSTRUMENT PANEL ASSEMBLY Exploded View 1. Center speaker grille 2. Tweeter speaker grille (LH) 3. Instrument panel 4. Instrument side mask (LH) 5. Combination meter 6. Lower knee protector (LH) 7. Cluster lid A 8. Instrument lower cover (LH) 9. Fuse block cover 10. Steering column cov ...

    Additional service when removing battery negative terminal
    Description Initial setting is necessary when battery terminal is removed. CAUTION: The following specified operations are not performed under the non-initialized condition. • Auto-up operation • Anti-pinch function • Retained power operation Special Repair Requirement INITIALIZ ...