Nissan Altima 2007-2012 Service Manual: ECM branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).

- ECM

- Harness connector E30

- Harness connector M1

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of ECM.

2. Check the resistance between the ECM harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the ECM branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the ECM. Refer to the following.

• QR engine models for California: EC-144, "Diagnosis Procedure" • QR engine models expect for California: EC-673, "Diagnosis Procedure" • VQ engine models: EC-1175, "Diagnosis Procedure" Is the inspection result normal? YES (Present error)>>Replace the ECM. Refer to the following.

• QR engine models for California: EC-27, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement" • QR engine models except for California: EC-563, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement" • VQ engine models: EC-1051, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement" YES (Past error)>>Error was detected in the ECM branch line.

NO >> Repair the power supply and the ground circuit.

    Main line between dlc and abs circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and co ...

    A-Bag branch line circuit
    Diagnosis Procedure 1.CHECK AIR BAG DIAGNOSIS SENSOR UNIT Check the air bag diagnosis sensor unit. Refer to SRC-3, "Work Flow". Is the inspection result normal? YES >> Replace t ...

    Other materials:

    FM/AM radio with compact disc (CD) player (Type A) (if so equipped)
    1. CD eject button 2. CD button 3. Display screen 4. CD insert slot 5. SEEK button 6. SCAN button 7. TRACK button 8. BACK button 9. iPod MENU button 10.TUNE/FOLDER knob, ENTER/SETTING button 11.Station select (1 - 6) buttons 12.RDM button 13.RPT button 14.VOL (volume) knob / butto ...

    Door outside molding
    Removal and Installation 1. Front door outside molding 2. Rear door outside molding Front Door Outside Molding Removal 1. Open the front door window fully. 2. Remove the side view mirror. Refer to MIR-19, "Removal and Installation". 3. Lift and twist from rear side, disconn ...

    M&A branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the combination meter for damage, bend and loose connection (unit side and connector side). ...