Nissan Altima Owners Manual: Emergency engine shut off

To shut off the engine in an emergency situation while driving, perform the following procedure:

– Rapidly push the push-button ignition switch 3 consecutive times in less than 1.5 seconds, or – Push and hold the push-button ignition switch for more than 2 seconds.

    In case of emergency
    ...

    Hazard warning flasher switch
    Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights flash. WARNING ● If stopping for an emergency, be sure to move the ...

    Other materials:

    U1010 control unit (CAN)
    Description Refer to LAN-9, "Description". DTC Logic DTC DETECTION LOGIC Diagnosis Procedure Symptom: Displays “CONTROL UNIT (CAN) [U1010]” as a self-diagnosis result of AV control unit. 1.CHECK CAN COMMUNICATION Select “SELF-DIAG RESULTS” mode for “MULTI AV” with ...

    Headlamp (halogen)
    Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp low relay based on inputs from the BCM over the CAN communication lines. When the headlamp low relay is energized, power flows through fuses 51 and 52, located in the IPDM E/R. Power then flows ...

    B2608 starter relay
    Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2608 is displa ...