Nissan Altima Owners Manual: Fog light switch (if so equipped)

To turn the fog lights on, turn the headlight switch


To turn the fog lights on, turn the headlight switch to the light position, then turn the fog
light switch to the position.


To turn the fog lights on with the headlight switch in the AUTOposition, the headlights must be on, then turn the fog light switch to the position.
position.

To turn the fog lights off, turn the fog light switch to the OFF position.

The headlights must be on and the low beams selected for the fog lights to operate. The fog lights automatically turn off when the high beam headlights are selected.

    Turn signal switch
    Turn signal 1 Move the lever up or down to signal the turning direction. When the turn is completed, the turn signal cancels automatically. Lane change signal 2 To signal a lane change, move ...

    Horn
    To sound the horn, push near the horn icon on the steering wheel. WARNING Do not disassemble the horn. Doing so could affect proper operation of the supplemental front air bag system. Tampering ...

    Other materials:

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connectors on CAN communication system. 4. Check terminals and connectors for damage, bend and loose con ...

    Meter system
    System Diagram System Description COMBINATION METER • Speedometer, odo/trip meter, tachometer, fuel gauge, engine coolant temperature gauge and information display are controlled by the unified meter control unit, which is built into the combination meter. • Warning and indicator la ...

    Anti-pinch system does not operate normally (passenger side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the ma ...