Nissan Altima 2007-2012 Service Manual: Front wiper and washer switch

Removal and Installation

NOTE: The wiper washer switch is part of the combination switch assembly.

REMOVAL

1. Remove the spiral cable. Refer to SR-8, "Removal and Installation".

2. Disconnect the combination switch connector and remove the combination switch assembly.

INSTALLATION

Installation is in the reverse order of removal.

    Front washer pump
    Removal and Installation Front washer pump is not available seperately, it is part of the washer tank. Refer to WW-119, "WASHER TANK : Removal and Installation". ...

    Defogger
    ...

    Other materials:

    P0447 Evap canister vent control valve
    Description The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal the ca ...

    Waxing
    Regular waxing protects the paint surface and helps retain new vehicle appearance. Polishing is recommended to remove built-up wax residue and to avoid a weathered appearance before re-applying wax. A NISSAN dealer can assist you in choosing the proper product. ● Wax your vehicle on ...

    Evaporator
    Removal and Installation COMPONENTS 1. Heater and cooling unit case 2. Evaporator 3. Intake sensor 4. In-cabin microfilter 5. Evaporator cover 6. Heater and cooling unit foot duct RH 7. Blower unit REMOVAL 1. Remove the heater and cooling unit assembly. Refer to HA-32, "HFC-134a ...