Nissan Altima 2007-2012 Service Manual: Function information

Component Part Location

ENGINE COMPARTMENT

1. A/C compressor F3

2. Ambient sensor E211

3. Refrigerant pressure sensor E219

4. A/C relay (internal to IPDM E/R)

1. A/C compressor F3

2. Ambient sensor E211

3. Refrigerant pressure sensor E219

4. A/C relay (internal to IPDM E/R)

PASSENGER COMPARTMENT

1. Intake door motor M126

2. Front blower motor relay J-4

3. Air mix door motor (LH) M128

4. Mode door motor M127

5. Blower motor M31

6. Air mix door motor (RH) M129

Component’s Role

    Function diagnosis
    ...

    Refrigeration system
    Refrigerant Cycle Refrigerant flow The refrigerant flows in the standard pattern, that is, through the compressor, the condenser with liquid tank, through the evaporator, and back to the compres ...

    Other materials:

    Blower unit
    Removal and Installation COMPONENTS 1. Heater and cooling unit 2. Blower unit Front REMOVAL 1. Remove the heater and cooling unit assembly. Refer to VTL-12, "Removal and Installation". 2. Disconnect the blower motor connector. 3. Remove the screws from the blower unit, the ...

    P1778 step motor - function
    Description • The step motor's 4 aspects of ON/OFF change according to the signal from TCM. As a result, the flow of line pressure to primary pulley is changed and pulley ratio is controlled. • This diagnosis item is detected when electrical system is OK, but mechanical system is NG. ...

    P1805 brake switch
    Description Brake switch signal is applied to the ECM through the stop lamp switch when the brake pedal is depressed. This signal is used mainly to decrease the engine speed when the vehicle is driving. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION ...