Nissan Altima 2007-2012 Service Manual: Idle speed

Description

This describes how to check the idle speed. For the actual procedure, follow the instructions in “BASIC INSPECTION”.

Special Repair Requirement

1.CHECK IDLE SPEED

Check idle speed in “DATA MONITOR” mode with CONSULT-III.

Check idle speed with Service $01 of GST.

>> INSPECTION END

    Additional service when replacing control unit
     Description When replacing ECM, the following procedure must be performed.  Special Repair Requirement 1.PERFORM INITIALIZATION OF NVIS (NATS) SYSTEM AND REGISTRATION OF ALL NVIS (NATS ...

    Ignition timing
     Description This describes how to check the ignition timing. For the actual procedure, follow the instructions in “BASIC INSPECTION”. Special Repair Requirement 1.CHECK IGNITION TIMIN ...

    Other materials:

    B261A push-button ignition switch
    Description BCM transmits the change in the power supply position with the push-button ignition switch to IPDM E/R via the CAN communication line. IPDM E/R transmits the power supply position status via CAN communication line to BCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCED ...

    Fuel tank
    Exploded View 1. Lock ring 2. Fuel level sensor, fuel filter, and fuel pump assembly 3. Seal ring 4. Fuel tank mounting straps 5. Fuel tank protector 6. Fuel tank 7. Fuel filler hose 8. Fuel filler hose 9. Grommet 10. Fuel filler cap Removal and Installation REMOVAL WARNING: Read ...

    Electric ignition system
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This signal is sent to the ECM through CAN communication line. *2: ECM determines the start signal status by the signals of engine speed and battery voltage. SYSTEM DESCRIPTION Firing order: 1 - 3 - 4 - 2 The ignition tim ...