Nissan Altima 2007-2012 Service Manual: Inside mirror

Exploded View

1. Inside mirror

2. Inside mirror finisher (if equipped)

3. Mirror base

Removal and Installation

1. Remove inside mirror finisher (if equipped).

2. Remove screw of mirror base.

3. Slide the mirror upward to remove.

4. Disconnect the connector (if equipped).

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: Apply Genuine Mirror Adhesive or equivalent to bonding surface of mounting bracket. Refer to GI-15, "Recommended Chemical Products and Sealants".

    Door mirror
    Exploded View 1. Nut 2. Mirror assembly 3. Door panel Removal and Installation REMOVAL 1. Remove the front door finisher. Refer to INT-12, "Removal and Installation". 2. Disconn ...

    Other materials:

    B2553 ignition relay
    Description BCM turns ON the following relays to ignition power supply to each ECU when the ignition switch is turned ON. • Ignition relay-1 (inside IPDM E/R) • Ignition relay-2 (inside fuse block) • Blower fan motor relay BCM checks any ignition relay ON request for consistency wit ...

    B2014 chain of strg-immu
    Description BCM performs the ID verification with the steering lock unit to release the steering. BCM starts the communication with the steering lock unit when keyfob is carried into the passenger compartment and the push-button ignition switch is pressed. DTC Logic DTC DETECTION LOGIC ...

    High-pressure pipe
    Removal and Installation for High-Pressure Pipe QR25DE Removal 1. Discharge the refrigerant. Refer to HA-24, "HFC-134a (R-134a) Service Procedure". 2. Remove the strut tower bar. Refer to FSU-12, "Exploded View". 3. Remove the upper cowl. Refer to EXT-18, "Remova ...