Other materials:

Microphone
Removal and Installation REMOVAL 1. Remove the room/map lamp assembly. Refer to INL-121, "Removal and Installation". 2. Detach the microphone connector (A). 3. Remove the map lamp covers (1), then remove the map lamp assembly cover (2). 4. Release the microphone tabs (A), th ...

P1722 Estm vehicle speed signal
Description The vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) to TCM by CAN communication line. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has ...

P0144 HO2S3
Description The heated oxygen sensor 3, after HC adsorption catalyst (Under floor), monitors the oxygen level in the exhaust gas on each bank. This sensor is made of ceramic zirconia. The zirconia generates voltage from approximately 1V in richer conditions to 0V in leaner conditions. Unde ...