Nissan Altima 2007-2012 Service Manual: Noise, vibration and harshness (NVH) troubleshooting
NVH Troubleshooting Chart
Use chart below to help you find the cause of the symptom. If necessary, repair or replace these parts.
×: Applicable
ID Registration cannot be completed
ID Registration Cannot Be Completed
DIAGNOSTIC PROCEDURE
1.PERFORM ID REGISTRATION OF ALL TRANSMITTERS
Carry out ID registration of all transmitters. Refer to WT-6, "ID
Registration Procedu ...
Precaution
Supplemental Restraint System (SRS) AIR BA
G and SEAT BELT PRE-TENSIONER
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat be ...
Other materials:
B26E1 No reception of engine status
signal
Description
BCM receives the engine status signal from ECM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B26E1 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
SEC-235, "DTC Logic".
• If DTC B26E1 is displayed wi ...
Symptom diagnosis
SRS AIR BAG SYSTEM
"AIR BAG" Warning Lamp Does Not Turn Off
DIAGNOSTIC PROCEDURE 7
1.CHECK CONDITION OF AIR BAG MODULE
Inspect for any deployed air bag modules or seat belt pre-tensioners.
Are any air bag modules or seat belt pre-tensioners deployed?
YES >> Refer to SR-20, ...
Reverse idler shaft and gear
Exploded View
Refer to TM-28, "Exploded View".
Disassembly
1. Remove reverse idler gear (Rear), reverse coupling sleeve, and reverse
insert spring simultaneously.
2. Remove reverse idler gear needle bearing.
3. Remove thrust needle bearing.
4. Remove reverse baulk ring.
5 ...