Nissan Altima 2007-2012 Service Manual: None of the power windows can be operated using any switch

Diagnosis Procedure

1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT

Check BCM power supply and ground circuit.

Refer to BCS-42, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH POWER SUPPLY AND GROUND CIRCUIT

Check main power window and door lock/unlock switch power supply and ground circuit.

Refer to PWC-19, "POWER WINDOW MAIN SWITCH : Component Function Check".

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace the malfunctioning parts.

3. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH

Check main power window and door lock/unlock switch.

Refer to PWC-19, "POWER WINDOW MAIN SWITCH : Component Function Check".

Is the inspection result normal? YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Symptom diagnosis
    ...

    Driver side power window alone does not operate
    Diagnosis Procedure 1. CHECK POWER WINDOW MOTOR LH Check power window motor LH. Refer to PWC-25, "DRIVER SIDE : Component Function Check". Is the inspection result normal? YES >& ...

    Other materials:

    P0130, P0150 A/F sensor 1
    Description The air fuel ratio (A/F) sensor 1 is a planar one-cell limit current sensor. The sensor element of the A/F sensor 1 is composed an electrode layer, which transports ions. It has a heater in the element. The sensor is capable of precise measurement = 1, but also in the lean and ...

    Front fog lamp circuit
    Description The IPDM E/R (intelligent power distribution module engine room) controls the front fog lamp relay based on inputs from the BCM over the CAN communication lines. When the front fog lamp relay is energized, power flows from the front fog lamp relay in the IPDM E/R to the front fog ...

    ECU diagnosis
    POWER STEERING CONTROL UNIT Reference Value TERMINAL LAYOUT PHYSICAL VALUES CAUTION: When using circuit tester or oscilloscope to measure voltage for inspection, be sure not to extend forcibly any connector terminals. Wiring Diagram — ELECTRONICALLY CONTROLLED POWER STEERING SYSTEM ...