Nissan Altima 2007-2012 Service Manual: Normal operating condition

Description

XENON HEADLAMP

• The brightness and color of the light may vary slightly immediately after turning the headlamp ON. This condition will remain until the xenon bulb becomes stable. This is normal.

• Illumination time lag may occur between right and left. This is normal.

AUTO LIGHT SYSTEM

The auto light system may not turn the headlamp ON/OFF immediately after passing a dark area or a bright area (short tunnel, sky bridge, shadowed area etc.). This is normal.

    Exterior lighting system symptoms
    Symptom Table CAUTION: Perform the self-diagnosis with CONSULT-III before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. ...

    Both side headlamps do not switch to high beam
    Description The headlamps (both sides) do not switch to high beam when the lighting switch is in the HI or PASS setting. Diagnosis Procedure 1.COMBINATION SWITCH INSPECTION Check the combinati ...

    Other materials:

    B2013 ID discord, immu-strg
    Description BCM performs the ID verification with the steering lock unit and releases the steering lock if both BCM and steering lock unit ID are same. BCM starts the communication with the steering lock unit when Intelligent Key is carried into the passenger compartment and the push-button ...

    B1118 – B1120 satellite sensor LH
    Description DTC B1118 – B1120 SATELLITE SENSOR LH The satellite sensor LH is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor the satellite sensor LH for internal failures and it's circuits for communication errors. PART LOCATION Refer to SRC-7, ...

    P0605 ECM
    Description The ECM consists of a microcomputer and connectors for signal input and output and for power supply. The ECM controls the engine. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always tur ...