Nissan Altima 2007-2012 Service Manual: Normal operating condition

COMPASS

Description

• The electronic compass is highly protected from changes in most magnetic fields. However, some large changes in magnetic fields can affect it. Some examples are (but not limited to): high tension power lines, large steel buildings, subways, steel bridges, automatic car washes, large piles of scrap metal, etc. While this does not happen very often, it is possible.

• During normal operation, the Compass Mirror will continuously update the compass calibration to adjust for gradual changes in the vehicle's magnetic "remnant" field. If the vehicle is subjected to high magnetic influences, the compass may appear to indicate false headings, become locked, or appear that it is unable to be calibrated. If this occurs, perform the calibration procedure.

• If at any time the compass continually displays the incorrect direction or the reading is erratic or locked, verify the correct zone variance.

    The ambient temperature display is incorrect
    Description • The displayed ambient air temperature is higher than the actual temperature. • The displayed ambient air temperature is lower than the actual temperature. Diagnosis Procedure ...

    Precaution
    Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used alo ...

    Other materials:

    Service data and specifications(SDS)
    Wheel Alignment (Unladen*) Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions. Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions. Ball Joint Wheelarch Height (Unladen*1) ...

    Forward-facing child restraint installation using LATCH
    Refer to all Warnings and Cautions in the “Child Safety” and “Child Restraint” sections before installing a child restraint. Follow these steps to install a forward-facing child restraint using the LATCH system: 1. Position the child restraint on the seat. Always follow the child res ...

    ECM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - ECM - Harnes ...