Nissan Altima (L32) 2007-2012 Service Manual: On-vehicle maintenance
PRE-INSPECTION FOR DIAGNOSTIC
Basic Inspection
1.INSPECTION START
1. Check the service history.
2. Check the following parts.
• Fuse/circuit breaker blown.
• Poor connection, open or short circuit of harness connector.
• Battery voltage.
Is the inspection result normal?
YES >> Inspection End.
NO >> Repair or replace the malfunctioning parts.
Diagnosis Procedure
1.REPLACE MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
Replace main power window and door lock/unlock switch.
Refer to PWC-186, "Removal and Installation". After th ...
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to
INT-34, "Removal and Installation".
2. Power window main swit ...
Other materials: Programming HomeLink for Canadian
customers and gate openers
Canadian radio-frequency laws require
transmitter signals to "time-out" (or quit)
after several seconds of transmission -
which may not be long enough for
HomeLink to pick up the signal during
training. Similar to this Canadian law, some
U.S. gate operators are designed to "timeout"
in the same mann ...
All-Wheel Drive (AWD) (if so equipped)
If any malfunction occurs in the AWD system
while the engine is running, messages
are displayed in the meter.
If the AWD error warning message is displayed,
there may be a malfunction in the
AWD system. Reduce vehicle speed and
have your vehicle checked. It is recommended
that you visit a NISSAN de ...
USB (Universal Serial Bus) Connection
Port
Type-A.
Connecting a device to the USB
Connection Port
WARNING
Do not connect, disconnect, or operate
the USB device while driving. Doing so
can be a distraction. If distracted you
could lose control of your vehicle and
cause an accident or serious injury.
CAUTION
To avoid damage and loss of f ...
Power window lock switch does
not function
On-vehicle repair