Nissan Altima 2007-2012 Service Manual: On-vehicle maintenance
Preparation
Special Service Tools
NOTE:
The actual shapes of Kent-Moore tools may differ from those of special service
tools illustrated here.
Commercial Service Tools
...
Fuel pressure
Inspection
FUEL PRESSURE RELEASE
1. Turn ignition switch ON.
2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode with CONSULT-III.
3. Start engine.
4. After engine stalls, c ...
Other materials:
Rear combination lamp
Bulb Replacement
Removal
1. Remove the rear combination lamp. Refer to EXL-260, "Removal and
Installation".
2. Turn the rear turn signal lamp bulb socket counterclockwise and remove it.
3. Remove the rear turn signal lamp bulb.
Installation
Installation is in the reverse order ...
Crash zone sensor
Removal and Installation
REMOVAL
1. Crash zone sensor harness connector
2. Crash zone sensor
A. Crash zone sensor nuts
CAUTION:
• Before servicing, turn ignition switch OFF, disconnect both battery terminals
and wait at least three
minutes.
• Do not use air tools or electric tool ...
Evaporative emission system
System Diagram
EVAPORATIVE EMISSION LINE DRAWING
1. Intake manifold collector
2. EVAP service port
3. EVAP canister purge volume control
solenoid valve
A. From next figure
1. EVAP control system pressure sensor
2. EVAP canister vent control valve
3. EVAP canister
A. To previous figu ...