Nissan Altima (L32) 2007-2012 Service Manual: On-vehicle repair
- Transmission control module
- Control device
- Control cable
- Differential side oil seal
- Air breather hose
- Park/neutral position (PNP) switch
- Primary speed sensor
- Secondary speed sensor
- Oil pump fitting bolt
- Control valve
CVT position
Inspection and Adjustment INSPECTION 1. Place selector lever in “P” position, and turn ignition switch ON (engine stop). 2. Make sure that selector lever can be shifted to other than “P ...Transmission control module
Exploded View 1. TCM 2. Bracket 3. Battery Removal and Installation REMOVAL 1. Disconnect the battery negative terminal. 2. Remove the fresh air intake tube (upper). 3. Disconnect the ...Other materials:
Air mix door motor
Description
SYSTEM DESCRIPTION
Component Parts
Air mix door control system components are:
• Front air control
• Air mix door motor (LCU)
System Operation
The front air control receives user inputs through its various dials and
switches. The front air control sends air
mix door, mode d ...
Center speaker
Description
The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker
amp. amplifies the audio
signals before sending them to the center speaker using the audio signal
circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect BOSE speaker amp. connector B121 and center ...
Inspection and adjustment
ADDITIONAL SERVICE WHEN REPLACING
CONTROL UNIT
Precaution for TCM and CVT
Assembly Replacement
CAUTION:
• Check if new data (Unit ID) are entered correctly after replacing CVT assembly
and erasing data in
TCM. (Connect CONSULT-III, and then turn ignition switch OFF.)
• When replacing CV ...