Nissan Altima 2007-2012 Service Manual: On-vehicle repair

On-vehicle maintenance
FRONT WHEEL HUB Inspection • Move wheel hub and bearing assembly in the axial direction by hand. Make sure there is no looseness of wheel bearing. Axial end play : 0.05 mm (0.002 in) or less ...

Front wheel hub and knuckle
Removal and Installation 1. Cotter pin 2. Disc rotor 3. Wheel hub and bearing assembly 4. Splash guard 5. Steering knuckle REMOVAL 1. Remove wheel and tire from vehicle. Refer to WT-66, &qu ...

Other materials:

P0740 torque converter clutch solenoid valve
Description • The torque converter clutch solenoid valve is activated by the TCM in response to signals sent from the vehicle speed and accelerator pedal position sensors. Lock-up piston operation will then be controlled. • Lock-up operation, however, is prohibited when CVT fluid temper ...

P1805 Brake switch
Description Brake switch signal is applied to the ECM via the stop lamp switch when the brake pedal is depressed. This signal is used mainly to decrease the engine speed when the vehicle is being driven. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION ...

Changing wheels and tires
Tire rotation NISSAN recommends rotating the tires every 7,500 miles (12,000 km). See “Flat tire” in the “In case of emergency” section of this manual for tire replacing procedures. As soon as possible, tighten the wheel nuts to the specified torque with a torque wrench. Wheel ...