Nissan Altima 2007-2012 Service Manual: On-vehicle repair
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to INT-34, "Removal and Installation".
2. Power window main switch (1) is removed from power window main switch finisher (2) using a suitable tool (A).
CAUTION: Do not fold the pawl of power window main switch finisher. NOTE: The same procedure is also performed for front power window and door lock/unlock switch RH, and rear power window switch (LH & RH).
INSTALLATION
Installation is in the reverse order of removal.
On-vehicle maintenance
PRE-INSPECTION FOR DIAGNOSTIC
Basic Inspection
1.INSPECTION START
1. Check the service history.
2. Check the following parts.
• Fuse/circuit breaker blown.
• Poor connection, open or s ...
Roof
...
Other materials:
Thermostat and thermostat housing
Removal and Installation
1. Thermostat
2. O-ring
3. Engine coolant inlet
4. Water control valve
5. Gasket
6. Engine coolant outlet
7. Copper washer
8. Engine coolant temperature sensor
9. Heater pipe
A. To electric throttle control
B. To oil cooler
C. To heater
D. To heater
E. To ele ...
Tire dressings
dressings. Tire manufacturers apply a coating to
the tires to help reduce discoloration of the rubber.
If a tire dressing is applied to the tires, it may
react with the coating and form a compound. This
compound may come off the tire while driving and
stain the vehicle paint.
If you choose ...
Camera image signal circuit (rear view camera to
camera control
unit)(sedan)
Description
Rear view camera images are transmitted to the rear view camera control unit
using the camera image signal
circuits.
Diagnosis Procedure
1.CHECK CAMERA IMAGE SIGNAL CIRCUIT CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect rear view camera control unit connector and rear ...