Nissan Altima 2007-2012 Service Manual: On-vehicle repair
BATTERY
Removal and Installation
REMOVAL
1. Remove air duct (front). Refer to EM-25, "Removal and Installation" QR25DE models, EM-129, "Removal and Installation" VQ35DE models.
2. Loosen battery terminal nuts, and disconnect both battery terminals.
CAUTION: When disconnecting, disconnect the negative terminal first.
3. Remove battery frame nuts and battery frame.
4. Remove battery.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: When connecting, connect the positive terminal first.
Reset electronic systems as necessary. Refer to PG-6, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Special Repair Requirement".
Preparation
Special Service Tool
Commercial Service Tool
...
Service data and specifications (SDS)
Battery
...
Other materials:
B2555 stop lamp
Description
BCM detects the stop lamp status and confirms the stop lamp switch ON/OFF
status. BCM confirms the
engine start condition according to the stop lamp switch ON/OFF status.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Depress ...
Rear spoiler
Removal and Installation
1. Rear spoiler assembly
2. High mounted stop lamp harness
3. Gasket
A. Nuts
Removal
1. Remove trunk lid finisher (if equipped). Refer to INT-23, "Removal and
Installation".
2. Disconnect high mounted stop lamp connector.
3. Using a trim stick, ca ...
BCM
Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuse or fusible link are blown.
Is the fuse or fusible link blown?
YES >> Replace the blown fuse or fusible link after repairing the affected
circuit.
NO >> GO TO 2
2. CHECK POWER SUPPLY CIRCUIT
1 ...