Nissan Altima 2007-2012 Service Manual: On-vehicle repair

BATTERY

Removal and Installation

REMOVAL

1. Remove air duct (front). Refer to EM-25, "Removal and Installation" QR25DE models, EM-129, "Removal and Installation" VQ35DE models.

2. Loosen battery terminal nuts, and disconnect both battery terminals.

CAUTION: When disconnecting, disconnect the negative terminal first.

3. Remove battery frame nuts and battery frame.

4. Remove battery.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: When connecting, connect the positive terminal first.

Reset electronic systems as necessary. Refer to PG-73, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Special Repair Requirement".

    Preparation
    Special Service Tool Commercial Service Tool ...

    Other materials:

    Refrigerant pressure sensor
    Description The refrigerant pressure sensor is installed at the condenser of the air conditioner system. The sensor uses an electrostatic volume pressure transducer to convert refrigerant pressure to voltage. The voltage signal is sent to ECM, and ECM controls cooling fan system. Componen ...

    Removal and installation
    ENGINE ASSEMBLY Removal and Installation 1. Torque rod 2. RH engine mounting insulator 3. RH engine mount support 4. Front engine mounting bracket 5. Front engine mounting insulator 6. RH engine mount bracket 7. Lower torque rod bracket 8. Lower torque rod 9. Rear engine mounting insulat ...

    P0442 evap control system
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0442 is displayed with DTC P0456, first perform the trouble diagnosis for DTC P0456. Refer to EC-841, "DTC Logic". This diagnosis detects leaks in the EVAP purge line using engine intake manifold vacuum. If pressure does not increa ...