Nissan Altima 2007-2012 Service Manual: P1700 CVT Control system

Description

This DTC is displayed with other DTC regarding TCM. Perform the trouble diagnosis for corresponding DTC.

Refer to EC-1555, "DTC Index". When this DTC is detected, the ASCD control is canceled.

    P1574 ASCD Vehicle speed sensor
    Description The ECM receives two vehicle speed signals via the CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses t ...

    P1715 Input speed sensor (primary speed sensor)
    Description ECM receives primary speed sensor signal from TCM via the CAN communication line. ECM uses this signal for engine control. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P1715 is d ...

    Other materials:

    Door switch
    Description Detects door open/close condition and transmits the signal to BCM. Component Function Check 1. CHECK FRONT DOOR SWITCH INPUT SIGNAL Check (“DOOR SW-DR” and “DOOR SW-AS”) in “DATA MONITOR” mode with CONSULT-III. Refer to BCS- 34, "RETAINED PWR : CONSULT-III Functi ...

    Camshaft valve clearance
    Valve Clearance CHECKING • Perform inspection as follows after removal, installation or replacement of camshaft or valve related parts, or if there is unusual engine conditions regarding valve clearance. Check valve clearance while engine is cold and not running. 1. Remove the air duct w ...

    IPDM-E branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - TCM - Harnes ...