Nissan Altima 2007-2012 Service Manual: Power Outtlet

On-vehicle repair
HORN Removal and Installation REMOVAL 1. Position aside the front fender protector LH. Refer to EXT-19, "Removal and Installation". 2. Disconnect the horn connectors (A). 3. Remo ...

Precaution
Supplemental Restraint System (SRS) AIR BA G and SEAT BELT PRE-TENSIONER The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a f ...

Other materials:

Forward-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudden ...

P1720 VSS
Description ECM receives two vehicle speed signals via the CAN communication line. One is sent from “ABS actuator and electric unit (control unit)” via the combination meter, and the other is from TCM (Transmission control module). ECM uses these signals for engine control. DTC L ...

Malfunction indicator lamp
Description The Malfunction Indicator Lamp (MIL) is located on the combination meter. The MIL will light up when the ignition switch is turned ON without the engine running. This is a bulb check. When the engine is started, the MIL should go off. If the MIL remains on, the on board diagno ...