Nissan Altima (L32) 2007-2012 Service Manual: Power supply and ground circuit (sedan)
AUDIO UNIT
Diagnosis Procedure
1.CHECK FUSES
Check that the following fuses are not blown.
Are the fuses OK?
YES >> GO TO 2
NO >> If fuse is blown, be sure to eliminate cause of malfunction before
installing new fuse.
2.POWER SUPPLY CIRCUIT CHECK
1. Disconnect audio unit connector M43.
2. Check voltage between the audio unit connector M43 and
ground.
Are the voltage results as specified?
YES >> GO TO 3
NO >> • Check connector housings for disconnected or loose terminals.
• Repair harness or connector.
3.GROUND CIRCUIT CHECK
Inspect audio unit case ground.
Does case ground pass inspection?
YES >> Inspection End.
NO >> Repair audio unit case ground.
Diagnosis Procedure
1.CHECK FUSES
Check that the following fuses are not blown.
Are the fuses OK?
YES >> GO TO 2
NO >> If fuse is blown, be sure to eliminate cause of malfunct ...
Diagnosis Procedure
1.CHECK FUSES
Check that the following fuses are not blown.
Are the fuses OK?
YES >> GO TO 2
NO >> If fuse is blown, be sure to eliminate cause of malfunction be ...
Other materials: System temporarily unavailable
For vehicles with the 7 inch (18 cm) display
Condition A:
In the following conditions, the AEB with
Pedestrian Detection system warning light
blinks and the system will be turned off
automatically:
The camera area of the windshield is
misted or frozen.
Strong light is shining from the front.
T ...
System Temporarily Unavailable
The following are conditions in which the
ICC system may be temporarily unavailable.
In these instances, the ICC system
may not cancel and may not be able to
maintain the selected following distance
from the vehicle ahead.
Condition A
Under the following conditions, the ICC system
is automatically ...
Turning the I-FCW system on/off
For vehicles with the 7 inch (18 cm) display
Perform the following steps to turn the
I-FCW system ON or OFF.
For vehicles with the 7 inch (18 cm) display.
1. Press thebutton until
"Settings" displays
in the vehicle information display.
Use the button to select "Driver
Assistance."
Then press the ...