Nissan Altima 2007-2012 Service Manual: Power window lock switch does not function

Diagnosis Procedure

1. REPLACE MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH

Replace main power window and door lock/unlock switch.

Refer to PWC-291, "Removal and Installation". After that, PWC-199, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".

Is the inspection result normal? YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Keyless power window down does not operate
    Diagnosis Procedure 1. CHECK INTELLIGENT KEY FUNCTION Check Intelligent Key function. Refer to SEC-16, "System Description". Is the inspection result normal? YES >> Check inte ...

    On-vehicle maintenance
    PRE-INSPECTION FOR DIAGNOSTIC Basic Inspection 1.INSPECTION START 1. Check the service history. 2. Check the following parts. • Fuse/circuit breaker blown. • Poor connection, open or s ...

    Other materials:

    B2609 steering status
    Description There are 2 switches in the electronic steering column lock (steering lock/unlock switch 1 and 2). BCM compares those two switches conditions to judge the present steering status. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2609 is displayed with DTC U1000, first perform the ...

    How to park with predicted course lines
    WARNING ● Always turn and check that it is safe to do so before backing up. Always back up slowly. ● Use the displayed lines as a reference. The lines are highly affected by the number of occupants, fuel level, vehicle position, road conditions and road grade. ● If the ti ...

    P1421 Cold start control
    Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P1421 is displayed ...